Objective

Applies To

• Bogen PCM-TIM overhead paging system (FXS Mode Only)

Procedure

You must connect the 8x8 adapter to a Tel Line or 90v NGT RNG port before configuring the Bogen PCM-TIM Overhead Paging System. Refer to the Bogen installation manuals. There are two versions or Hardware revisions of the Bogen PCMTM. Refer to the images below step 3 to identify the revision being configured. Both of the images are FXS Only.

1. Ensure that only DIP Switch 6 is ON Version 1.
2. Ensure that DIP Switch is set to Station Version 2
3. Using the phone line or RJ11 cable, connect your 8x8 adapter to the Tel Line (v1) or 90v NGT RNG (V2) port.

Version 1	Version 2

Additional Information