Objective
Resetting an Obihai adapter when unable to access the ATA Web Graphical User Interface (GUI).
- Obtained the correct ATA adapter IP address.
- Adapter and computer are on the same network.
- When trying to access the IP address on any browser you received an error "site can't be reached."
 |
IMPORTANT: Obihai ATA 300/302/508 devices are now EOL. |
Applies To
- Obihai ATA Adapters
Procedure
To perform the hard reset you will need a paper clip (or similar item) to depress the reset pin.
Resetting an Obihai Adapter
- Using the end of a paperclip, depress the reset pin, located on the bottom-left side of the Obihai. As illustrated below, it is located on the left side of the Obihai. Note: Be sure the paper clip is inserted straight and perpendicular to the box and not at an angle.
- While keeping the reset pin depressed, plug-in the power cord.
- The Power LED will turn red, then become solid green.
- Keep depressing the reset pin while this is occurring.
- After 10 seconds, the Power LED will start to flash green (slowly).
- Release the reset pin.
- Within 5 seconds, the Power LED will start to flash green rapidly for about 3 seconds.
- Next the Power LED will change to red briefly indicating the OBi is now rebooting.
The factory reset is now complete.