Bogen PCM-TIM Overhead Paging System Configuration

Updated: 07/11/2024

Objective

Configuring a Bogen PCM-TIM overhead paging system for 8x8 services.

Applies To

  • Bogen PCM-TIM overhead paging system (FXS Mode Only)

Procedure

You must connect the 8x8 adapter to a Tel Line or 90v NGT RNG port before configuring the Bogen PCM-TIM Overhead Paging System. Refer to the Bogen installation manuals.
There are two versions or Hardware revisions of the Bogen PCMTM. Refer to the images below step 3 to identify the revision being configured. Both of the images are FXS Only.
  1. Ensure that only DIP Switch 6 is ON Version 1.
  2. Ensure that DIP Switch is set to Station Version 2
  3. Using the phone line or RJ11 cable, connect your 8x8 adapter to the Tel Line (v1) or 90v NGT RNG (V2) port.
Version 1 Version 2
Bogen_PCM_TIM_Paging_Config.png
PCMTIM2.jpg

Additional Information

There are three Bogen PCM models and differing version releases. Refer to Bogen Resource Library for more information.