Bogen TAMB2 Overhead Paging System Configuration

Updated: 05/14/2024

Objective

Configure a Bogen TAMB2 overhead paging system for 8x8 services.

Applies To

  • Bogen TAMB2 Overhead Paging System

Procedure

Always refer to the original device manual or work done by a factory trained and certified installer.
  1. Ensure that only DIP Switch 1 is ON.
  2. Connect the phone line or RJ11 cable to your 8x8 adapter.
  3. Use a wire cutter to strip the other end of the cable and attach the wires to the corresponding pins on the Bogen TAMB2:
    • Red Wire: Station/Trunk Port Ring (R)
    • Green Wire: Station/Trunk Port Tip (T)
      Note: The black and yellow wires of the cable are not used.
Bogen_TAMB2_Paging_Config.png